Martin January 28, 2021 for Model Number shx46a05uc/23 I have a Bosch dishwasher, model #shx46a05uc/23 from about 2005. The dishwasher closes door closes, but does not latch shut. If I turn it on, the cycle will run whether or not the door is open. Any ideas?
1 Answer Martin, based on the information provided, it sounds like the latch assembly 00419828 is stuck in the locked position and would need to be replaced. Read More...
Julie March 26, 2019 for Model Number SHE55M16UC/64 Using your video I replaced my broken door latch. However, I inadvertently shut the dishwasher door while I was installing the new latch. Now the interior of the door is shut and latched, but I haven't reattached the control panel or bottom exterior panel. How do I get the dishwasher open to finish the repair?
1 Answer Julie, the door latch should be able to pull away from the strike. If you pull the inner door panel as if you were opening the door as normal, the latch should disengage. Read More...
Mike October 13, 2018 for Model Number SHP68T55UC Bosch All buttons work when door is open but as soon as I close the door all the lights on the panel go out. The dishwasher appears to run full cycle but all lights are gone as soon as the door is closed. Open the door mid cycle and all the lights come on but when door is closed no lights? What is causing this?
1 Answer Mike, The way this unit is designed, it should shut the lights off when closed as this is kind of like a energy saving feature especially if the unit is running through the cycle. Read More...
Brian January 07, 2018 for Model Number SHX45P05UC/60 My dishwasher would not close nor reset. I was told I needed to replace the door latch part #00438026 which I did. The washer ran one cycle and kept beeping at the end of the cycle. I opened the door and went to run another load and again the door won't close. It's like the latch is not being reset or something. Is there a sensor or some other part that has gone bad?
1 Answer Brian, No, there are no " sensor or some other part that has gone bad " and you did install the correct door switch assembly 00438026 / 00438026 But you'll need to check the wiring for loose or damaged connections, and check the fascia mounting plate and tabs to make sure the assembly is properly installed and operating properly. " Remove T-20 Torx fascia panel screws from inner door. Lower fascia panel from door. Locate door latch in console. Bend out console metal tabs to allow latch removal/installation." NOTE:Door latches for UC/14 & up models are different than UC/06 - UC/12 models -- they cannot be interchanged. Must replace strike plate & door latch together. You'll need to check the door latch and handle to make sure everything is aligned and operating properly. Read More...
Karl March 03, 2017 for Model Number SHX46B06UC/14 My Bosch dishwasher SHX46B06UC/14 won't start. When I push the on/off button with the door open (under counter model with controls on top of the door), the Regular Wash button light comes on, but when I close the door it goes off. Would this be caused by a bad door latch switch?
1 Answer Karl, You will want to test the door latch to make sure that there is continuity. If there is continuity on the switches then the latch is good and the issue will most likely be in the control module. Read More...
Sally January 20, 2017 I have a Bosch 00419828 door latch assembly. I replaced the latch but now cannot get the old strike out (does not work with old strike but works with new one) to get new one in. Any suggestions?
1 Answer Sally, To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Nick July 28, 2016 for Model Number SHV4303UC/U11 My Bosch SHV4303UC/U11 dishwasher refuses to start. All indicators and cycle selection start/stop buttons appear to work, but the machine will not run once the door is closed. Is this most likely to be the Door Latch Switch? Could it be something else?
1 Answer Hello Nick. You will need to test the latch assembly on the unit to see if it was working properly. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Tom June 21, 2016 for Model Number SHE43M05UC/50 Bosch Latch does not lock, but operates,, also can open while running, water continues to flow in....can I fix myself? And if so what part do I need to buy to replace. Thanks for your assistance
1 Answer Hello Tom. It sounds like you will need to replace the latch 00438026 on the unit. Read More...
Roberto October 25, 2015 for Model Number SHU8805 UC/12 (FD 8105-) I can't completely close the door on my Bosh SHU880UC. The lock seems stock with the Power Scrub and Quick Scrub button switch blinking. The dishwater will still run even if the door is open.I've turned on and off the circuit breaker with no success. Thanks.
1 Answer Roberto, If the unit is running with the door open then this would be a door latch issue in which you will want to replace the door latch 00419828. Read More...
Sydney March 03, 2014 for Model Number Bosch SHU9905UC 406 Dishwasher No power, all house wiring is fine, just seems to be no power to the door switches. Does this mean replacing the main control module or wiring harnesses or both? Other than this recent thing, the dishwasher has always worked like a true champ, worked last night no probs, this morning, loaded dishwasher up and realized none of lights on switches are working appears dead.
1 Answer Hello Sydney. Test for power at the junction box of the dishwasher and check all the wires. Replace the door switches if they are bad on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...