Sara for Model Number WFR2460 UC/01 (FD 8201-) I was getting a "water tapped closed?" message a few minutes into a cycle. It didn't always happen and when it did, I just hit the pause/start button and the cycle would continue. But, then one day, the message appeared at the beginning of the cycle and the cycle would not restart. After some research, I installed new hot water and cold water valves. That seemed to resolve the problem for a couple of loads. But, now I am getting the message again at the beginning of the cycle, before water flows through the detergent dispenser. What part should I try replacing next?
Answer Sara, "water tap closed?" indicated in the display field could be due to: Supply hoses kinked or trapped, eliminate the cause. Strainers in supply hoses clogged, Clean the filters. Water pressure too low. Eliminate the cause." With new water inlet valves, you may want to remove and check and clean the fill hose washers and screens, Open and flush the hot and cold water faucets for a minute or two, Then put it all back together and check the operation. If the problem persists, then check the 00602819 / 00602819 water inlet flow meter/ sensor, and wiring to the control board. Read More... Answered by AppliancePartsPros.com | Tuesday, March 6, 2018