Charles October 01, 2019 for Model Number wfl2060uc oem bosch washer hot valve is 173369 which subs to 00428212 but electrical connectors are different. Is there an adapter?
1 Answer Charles, there should be a number that is after a backslash. This number is a series number that is part of the model and would be necessary to provide the most accurate information regarding part numbers. If this number could be included in a new inquiry, this will allow for the most accurate information to be presented. Read More...
Sara March 01, 2018 for Model Number WFR2460 UC/01 (FD 8201-) I was getting a "water tapped closed?" message a few minutes into a cycle. It didn't always happen and when it did, I just hit the pause/start button and the cycle would continue. But, then one day, the message appeared at the beginning of the cycle and the cycle would not restart. After some research, I installed new hot water and cold water valves. That seemed to resolve the problem for a couple of loads. But, now I am getting the message again at the beginning of the cycle, before water flows through the detergent dispenser. What part should I try replacing next?
1 Answer Sara, "water tap closed?" indicated in the display field could be due to: Supply hoses kinked or trapped, eliminate the cause. Strainers in supply hoses clogged, Clean the filters. Water pressure too low. Eliminate the cause." With new water inlet valves, you may want to remove and check and clean the fill hose washers and screens, Open and flush the hot and cold water faucets for a minute or two, Then put it all back together and check the operation. If the problem persists, then check the 00602819 / 00602819 water inlet flow meter/ sensor, and wiring to the control board. Read More...
Edgar November 20, 2015 for Model Number WFMC3200UC01 Hot water won't shut off, overfilling drum...cold water works fine.
1 Answer Hello Edgar. You will need to order and replace the water valve 00422245 on the unit. Read More...
Shauna January 30, 2015 for Model Number WFL2060UC 8302 Our washer is flowing hot water through the soap dispenser and not shutting off (draining the hot water tank!) It will continually keep running hot water through the soap dispenser, into the drum, overfilling the drum causing it to try to drain to keep up or cause an overflow, even when we select a cold only wash. Would a bad hot water inlet valve cause this? What is the model number of the one I need?
1 Answer Shauna, Based on the hot water continually flowing the issue would be caused by a faulty hot water valve part number 00428212. Read More...
1 Answer Hello Ted. The question has been answered. Thank you for using Appliancepartspros.com . Read More...
Ted N. May 01, 2011 for Model Number WFL260 Two weeks ago I guessed wrong and replaced the Hot/Cold water valve part #AP385434 price $30.59)for my Bosh Washing Machine. The machine still would not stop filling so it must be the cold water valve, part #AP3857699 that I need. My question is since this is a simpler part to make, it only hooks into the cold water why does it cost $34.02 when the other part that hooks into both the hot and cold water cost $30.59. Also, do you agree with my needed part?
1 Answer Hello Ted. The prices are based on demand for a part and manufacture cost. If you can stop the water with the power on the washer, you will need to check the pressure hose and the water level regulator 00600925. If the hose is good, you will need to replace the regulator. If you have to turn off the water at the shut off, you will need to replace the cold water valve. Hope this helps. Read More...