Doug for Model Number AW300KD1 will spin but not agitate. Can't figure out how to get the agitator off. The nut holding it on is flush with top of agitator and I don't see a cap to pry loose to gain access. Is the agitator belt driven?
Answer Hi Doug. The washer drive belt is part #134511600. The agitator is part # 3204401. Remove the belt, Test the motor to see if it will run in both directions on agitation ans spin. If not then you will need to mke sure the timer is giving the motor 120vac in both commands. The motor part # is 3205647. The belt is part # 134511600. Remove the Top tub cover (unclip) and use a flashlight to see if there is any balled up clothes stopping the tub. You can also push down hard on the fabric softner cup and while in agitation, see if the transmission gears are noisey and stripping. Transmission part # is 134735700. Use a rubber mallot to tap on the agitator to lift it off the shaft. There is trunion /plate assy under the inner tub that breaks a bolt and needs replaced. Part # is 131545101. The plate is part # 137107000. The bolt is part # 137539500. Thank You. Read More... Answered by AppliancePartsPros.com | Wednesday, October 5, 2011