Patti for Model Number ATF6000ES1 Hi. my Frigidaire affinity front loader originally wouldn't finish the cycle and would leave clothes still wet. After this happened several times I ran a diagnostic test and got E5E error code. Unplugged washer and tried to start a load. Will not fill, just keeps counting down time. ran diagnostic test again and now says E41. I installed new door latch kit (did this already about 18 mos ago after a similar experience), but still getting same error E41. I'm now thinking i want to change out Motor Control Board. Opened up back and am looking for some advice on how to get the old one out before I order a new one from you guys. If I cant do this myself, might just scrap the washer. The motor and belt seem to be in the way. Do I have to remove them? any advice would be GREATLY appreciated!!! Thx!
Answer Patti, With getting the E5E error code and then getting the E41, this issue will be more likely the main control board instead of the motor control. You would want to replace the control board 134523106. Read More... Answered by AppliancePartsPros.com | Friday, April 29, 2016