Randy M for Model Number FGHD2433KF1 Started a wash cycle and machine ran for about 2 minutes. Then the control panel blacked out and came back on about 2 hours later but showed a power failure code. Restarted washer and same thing happened again. Found a broken door latch and replaced it. Now there are no lights on the control panel and will not start. Owners manual says it could be the control board or the control panel so replaced the control board. Still no lights on the panel. Checked power during all this trouble shooting with an "AC circuit sensor and everything shows it's getting power including the control panel. Machine also has standing water in the bottom that hasn't drained out. Removed the lower spray bar and the strainers and haven't found anything. Drain hose is not plugged. Unit has run fine for 2 years till now.
Answer Hello Randy. Check the breaker and the junction box under the unit. If all is good, it sounds like the console assembly 154791806 is the issue with the unit. Read More... Answered by AppliancePartsPros.com | Tuesday, September 24, 2013