Greg for Model Number GSD5360F01SS Hello. I have a GE Triton dishwasher that is not draining completely at the end of the cycles. You recently answered my question about this, and suggested, after checking all the hoses and drains for obstructions, that I change the discharge pump. I checked everything, hoses, took drains apart and cleaned them, etc. The pump will discharge water at the end of the cycle, just not all of it. None of the cycles, wash, rinse only, etc. will empty the machine completely. there is always about an inch and a half of water in the machine. What else can I check? Could the timing board, sensor, or whatever it uses be bad? And if so, is it in the panel behind the touch operation panel? Please advise, as I am leaving it apart until I get some suggestions. As usual, any help is much appreciated.
Answer Hello Greg. If the lines are clear, then it sounds like the pump is not draining fast enough to empty all the water and the pump will need to be replaced on the unit. It should run for about 1 to 2 minutes at the end to clear the water out of the tub assembly. Make sure the check valve WD22X10025 is not restricting the water flow as well. Read More... Answered by AppliancePartsPros.com | Wednesday, January 2, 2013