Customer Questions and Answers for Refrigerator Damper Assembly by Ge

Hello Rick. The gasket is the correct size and will compress. The spout piece will go into the damper side of the assembly. 1. Remove light shield... more and rear light bulb from the top tower of the refrigerator. 2. Pull top two shelves out approximately two inches. 3. Pull tower assembly with both hands. Push tower right then left to expose screws. Remove screws. 4. Remove air duct by pulling straight back. Some models have complete horseshoe, some models have air duct on either side of light, and some models do not have an air duct. 5. Remove filter housing cover. Press in left side and pull straight out. Remove light assembly by removing four to eight screws (depending on model). 6. Remove existing damper assembly. 7. Install new damper assembly wr49x10091 8.. Reinstall all parts. When reinstalling light shield, screw in frame on one side, then position aluminum light housing, and finally screw in other side of frame. When reinstalling air duct, hold up duct in its proper grooves, then slide duct backwards. Make certain air duct tabs go in slots as shown.