Customer Questions and Answers for Suspension Rod And Spring Assembly by Ge

Harry, It is an involved procedure, but doable, heres some help: "Locate 2 spring clips between the top cover and front panel by aligning a putty knife with left or right edge of lid. Insert the putty knife and push forward to release clips. Rotate the front panel forward and lift off the bottom tabs. To remove the cover/lid assembly: Remove the front panel. Remove the lid switch. Remove the two ¼-in. hex screws securing the front of the cover/lid assembly to the cabinet. Pull the top cover toward you while lifting up the front edge to release the side catches. Slide the top cover to the left to release from the 3 tabs. The front and rear rod and spring assemblies have different spring compressions and should not be interchanged. The rods are color-coded to ensure they are replaced in the correct position. Note the color location before removing. Disengage the front rod and spring assemblies by raising the tub and removing the spring assemblies from the platform. The tub assembly will now lean forward. This allows clearance to reach behind the tub and access the rear rod and spring assemblies if necessary." Good Luck and Thanks