Sena for Model Number wm2277hw 6 months ago I replace the drain pump and it was functioning fine, now started leaking from the door and I changed the door gasket , hinges assembly and door lock assembly, after then the washer run about 10 minutes and stop; indicate LE sign which says over load and also not draining the water. It did this without load and with load as well. What should be the problem. THanks
Answer Hello Sena. • The connector (3-pin, male, white) in the MOTOR HARNESS is not connected to the connector (3-pin, female, white) of STATOR ASSEMBLY. • The electric contact between the connectors (3-pin, male, white) in the MOTOR HARNESS and 4-pin, female, white connector in the MAIN PWB ASSEMBLY is bad or unstable. • The MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut (open circuited). • The hall sensor is out of order/defective. Read More... Answered by AppliancePartsPros.com | Wednesday, February 6, 2013