M. Smith for Model Number WM2277HW My LG washer's tub stopped spinning. In Trouble Shooting mode, the drum will move slightly and then shake a little. I measure each winding set of the stator, each combo was about 8.1ohms. Again, with the washer in T/S mode I measured 208V on 2 combos and 0 on the third. I ordered the 6871ER1003C Control Boards (incorrectly listed on this site), but I am getting the same result. Except for one difference. I am only getting 208V on on output combo from the new board.
Answer M. Smith, This issue sounds like it would be caused by a rotor position sensor 6501KW2002B which is the most common reason for the tub to not spin and to be jumpy in the test mode. Read More... Answered by AppliancePartsPros.com | Thursday, October 24, 2013