Customer Questions and Answers for Washer Electronic Control Board by Whirlpool

Hello Lucas. Here are the instructions from the manufacture for testing the control board. Hope this helps. Rotate the Cycle Selector Knob to the “Power Off” position and press knob. (All LED’s will be off). Rotate the Cycle Selector Knob clockwise past “Power Off” twice and stop at “Regular”. (LED’s will illuminate as the knob is rotated). Rotate the Cycle Selector Knob counterclockwise one revolution back to “Regular” and press knob. • Power Off, Rinse & Spin LED will blink (if error codes are present). Regular LED will be illuminated. • Model I.D. is displayed by the LED’s around the bottom of the dial. • Model I.D. can be redisplayed while in Service Mode by setting knob to “Handwash” and pressing. • Refer to chart for Model I.D. Enter Service Mode then set Cycle Selection Knob to “Regular” and press knob. • Fill and Wash LED’s illuminate. Hot water fill. • Press knob Fill and Rinse LED’s illuminate. Cold water fill. • Press knob Fill, Wash, and Rinse LED’s illuminate. Selected wash temperature fill. • Press knob Wash LED illuminates. Slow agitation. • Press knob Wash LED blinking. Fast agitation. • Press knob Spin LED illuminates. Slow spin. • Press knob Spin LED blinking. Fast spin. • Press Knob Complete LED illuminates. • Press knob exit back to Service Mode. NOTE: Fills are skipped if Pressure Switch is satisfied. Press knob until Pause LED begins blinking to pause cycle. If there is no codes, or unit does not complete the service cycle, you will need to replace the control board.