Customer Questions and Answers for Oven Control Board by Whirlpool

Hello Andy, Turn the breaker to the unit off and verify there is no power to the unit. Open the oven door and look near the bottom for a screw on each side holding the trim on. Remove these two screws and pull the trim toward you about 2 inches and then pull them straight down toward the floor, this will expose the two screws at the bottom of the control panel that were covered by the trim. Removing these two screws, (one on either side), will enable you to pull out and push up on the control panel to remove it from the unit. Be careful of the wiring. I strongly recommend to transfer each wire/connector one at a time so you don't become confused on wire/connector placement. Remove the old board from the panel and install the new one. Reverse these instructions to re-assemble.