Richard for Model Number RBS245PDQ16 Oven goes into Lock after reaching about 300 and indicates error code E2 F3. Do you think this is the control board? If so, is replacing the control board in a RBS245 similar to the instructions I see listed for the RBS305? Remove screws at bottom, remove trim, remove board keeping track of harnesses?
Answer Hello Richard, The procedures will be the same in these two models. The difference here is the internal circuitry and the features on the display. The E2-F3 is the fault code for the oven temperature too high (over 575° in cook mode). 1. Check sensor connection. 2. Measure sensor resistance (1080O at [70°F]; add 2O per degree). If resistance is not valid, replace sensor. 3. If sensor resistance and connections are good, then the oven cavity temperature must have exceeded a safe level. Check for welded-closed relays on the control. Read More... Answered by AppliancePartsPros.com | Wednesday, January 15, 2014