Ronald Based on the noise, I assumed that there was probably a problem in the gear case. However, based on the fact that the motor now doesn't run (the machine is disassembled), I thought I'd try a new capacitor (not expensive). I don't know if the motor is OK, however there was no burning smell when the machine died and I disconnected it immediately after the agitator stopped. I want to verify where the problem lies before I buy any more parts, but am trying to figure out how to check the motor and the gear case. The coupling is worn and should be replaced, but it was basically intact.
Answer Hello Ronald. You can turn the transmission by hand and determine if it is bad. As for the motor. If you do a test on the unit and it does not run, just hums, and the capacitor is good, then either the timer or the motor is bad. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More... Answered by AppliancePartsPros.com | Thursday, September 3, 2015