Customer Questions and Answers for High Limit Thermostat Kit by Whirlpool

Wes, A model number would have been a big help. But the thermostats and fuses would not have an effect on the dryer start and run, at this point. I presume this is a GAS dryer so : The red wire from the timer should attach to one of the terminals on the hi limit switch. The red with white stripe wire shouls attach to the other terminal and route over and attach to one terminal of the cycling thermostat. The two purple wires should attach to the two small terminals of the cycling thermostat, as well. The other red wire will attach to the other large terminal of the cycling thermostat abd will route and attach to the terminal of the thermal fuse. The Blue wire fom the gas valve wiring harness will attach to the other terminal of the thermal fuse. and one blue wire should attach to the terminals of the radiant/flame sensor, on the burner housing. That should get the thermostats wired and ready to go. Make sure, one of those red wires is not the motor circuit wire. There is a red wire that attaches to the motor at one end and the push to start switch at the other. That may be thr reason for your no start issue. Good Luck.