Doug for Model Number Kitchen aid KGRT607HBS9 Just ordered and installed control assembly 9782455. Proceeded with End of Service Test a number of times to step 13. No display per instructions past this point. After pressing Start, receiving error F1-E3. Research tells me that this error code is: "Wiring Harness Cavity Size Does Not Match Stored Value - Check the jumpers in the harness to make sure they agree with the actual oven size" What does this mean? New contol panel connections look identical. Have disconnected and reconnected all numerous times in the same manner as removed from the replaced control panel. Key pad works fine - have been using the range without display lights for months. Please provide specifics. Thank you.
Answer Hello Doug. Check and make sure the pin in the connectors are making contact with the pins on the control board. Also, if the connections are good, you need to try to run the end of service test sequence. Hope this helps. End of service test sequence: For Convection Units: 1. Press CONVECTION BROIL. 2. Press CLEAN. 3. Press BAKED GOODS. 4. Press STOP TIME. 5. Press 1. 6. Press 9. 7. Press 0. 8. Press TIMER SET-START. 9. Wait 3 seconds. The clock display will show “6AS” and one of the following: - “hb-FS”, for Hidden Bake Free Standing units (with top light), - “Eb-FS”, for Exposed Bake Free Standing units (with top light), - “hb-SI”, for Hidden Bake Slide In units, and - “Eb-SI”, for Exposed Bake Slide In units. 10. Next, in order to confirm proper function for each feature, keep pressing START until control scrolled through all features. Read More... Answered by AppliancePartsPros.com | Friday, November 4, 2011