Klaas for Model Number MED6000AW0 The screen was inserted wrong (and somehow went down despite the groove design to prevent it), and in trying to wiggle it loose, broke both w10219016. I just ordered two new ones from your site, but I can't for the life of me figure out where they go, even looking at the schematic on your site, and how to replace. I unscrewed two screws on the inside on the plastic housing, and two screws on the outside, but that is as far as I got. Can't seem to be able to lift out the plastic housing where somewhere inside, these parts belong.
Answer Klaas, Unplug dryer or disconnect power. Turn off gas supply to dryer. Open the dryer door and remove the lint filter screen. Remove the two front screws from the outlet grille.Remove the three inside screws from the outlet grille.Pull the moisture sensor away from the dryer and disconnect the black and yellow-red wires from the moisture sensor strips. Once you have the two pieces separated you can remove the old doors and snap the new doors in place. Read More... Answered by AppliancePartsPros.com | Thursday, April 17, 2014