Customer Questions and Answers for Small Surface Element by Whirlpool

Roy, Unplug range or disconnect power. Pull the range forward so you can access the two end cap screws. To remove the electronic oven control (EOC) assembly on slide-in models: Remove the two screws from the sides of the left and right end caps. Open the oven door and remove the screws from the bottom of the control panel. Pull out on the bottom of the control panel, unclip the top edge from the bracket, and rotate the control panel forward so you can access the components. Label and ) Disconnect the wire connectors from the electronic oven control board and the ribbon cable connector(you could also take a photo). Remove the screws from the left and right side trim, and then from the rear trim. Remove the trim pieces from around the cooktop glass. Remove the cooktop glass brackets from the left and right sides of the range. Lift the rear of the cooktop glass off the range, slide it out from under the front control bracket, and remove it. ) Label and disconnect the wires from the limiter and element terminals. Lift the element and limiter and remove the spring clips from the support rail slots. Reverse the proceure to install the replacement part.