Stuart for Model Number Kenmore Dryer 110.62942100 This dryer stopped heating and the start switch stopped working (that is, if you hold the switch on, the dryer runs, but if you release pressure, the dryer stops running. Both of these happened simultaneously, so I assume they're related. I haven't been able to figure out the problem. Here's what I've tested: Checked for continuity--all passed: thermal fuse thermal cutoff thermostat heating element start switch Checked the thermistor and it has resistance; when it is heated, the resistance decreases, so it seems okay. Checked the two relays in the control panel by swapping one for the other. Nothing changed; still no heat, and won't stay running without pressure on the start switch. I noticed some corrosion on one of the heating elements connecting wires, so I stripped the wire back, and at the point where the wire looked healthy, I wrapped tightly around the heater element terminal. It did not solve the problem. I'm at a loss as to what is causing this, and would appreciate some advice. Thanks.
Answer Stuart, For this issue, the dryer motor would be the most likely cause. One line of power to the heating element will go through the motor and also switches the motor windings over so from start to run. Read More... Answered by AppliancePartsPros.com | Friday, May 22, 2020