Trent for Model Number MLE2000AYW I have a Maytag Neptune front load washing machine and dryer stacked. I replaced the pump I bought from your site, but the clothes are still wet at the end of operation. The R11 is fine, the unit is balanced, and I tried it with no clothes in it and there was still water in the drum. From all I have seen, and since it does not seem to be spinning out, the motor is the last option. What part do I need to buy to replace this? Or do I only need to buy part of this assembly? Thank you.
Answer Trent, Are you sure there is water left in the tub ? if so you need to check the drain hose(s) for clogs or kinks. you may be hearing the liquid balnce ring in the front of the tub, sounds like water is splashing. The washer has to drain and the water level switch reset to "empty" so the washer can spin properly, check the air dome hose and switch. From there check the spin enable switch circuit( switch on the latch assembly on the right side with the yellow and red wire attached, If the switch or wiring is defective, the door will lock, but the tub won't spin. Good Luck and Thanks Read More... Answered by AppliancePartsPros.com | Wednesday, October 12, 2011