Customer Questions and Answers for Evaporator Fan Motor Kit by Whirlpool

Chris, When you install the new motor you will need to use all parts that come with it. There is not specific instructions for doing this. To install the new part you will need to disconnect the power to the unit and access the fan motor. Once the fan motor has been accessed you will disconnect the plug on the side of the fan housing. Remove the fan housing from the unit by removing the screw on either side. Once out, pull the fan blade off and push up on the bottom of the fan to release the retaining clips from the holder that wraps under the motor. Once out you will use the new bracket to install but still use the same grommets. To attach the wires you will put the blue wire to one terminal and the white to the other. There is a smaller terminal for the green ground. The connector will get reconnected to the housing. Once you have this done reinstall the housing and connect the refrigerator connector to it and run the ground wire to the left where the other ground wire is located on the evaporator sheathing. Reassemble unit and plug in.