Dan for Model Number YKESC308LS0 No display. Unable to use any burners. Can do a "End of Service Test Sequence" if I press one of the burner controls and release it in "LO", "HI" position, but if I set it back to "OFF" the power and display goes blank again. When I set the burner to "Lo" or "Hi" the "control lock" then "PF" comes on, I can then do the "End Of Service Test Sequence". Any ideas??
Answer Dan, Sounds more like a power supply issue, than a range or control issue. If your power leg (120 VAC) or the neutral leg is dropping out "under a load" (when you turn a component on) You could get erratic displays and strange operations and read outs. You should get an electrician in , and have him check the power supply at the range "under a load" and go from there. Good Luck and Thanks Read More... Answered by AppliancePartsPros.com | Friday, January 27, 2012