Aaron B Ive got a Maytag Epic Z Front Load Washer. When it gets to the spin cycle it stops as if the cycle is done.No error codes on the display just a locked door. It leaves the machine full of water. Only error code we get is earlier in cycle, and SD code. AT that point is adds water and within a few minutes clears until failing at the spin cycle. I checked the filter at the drain and found it all clogged up. I cleaned it out, put my finger in around the entry to the drain pump itself which felt clear. Started machine again but ultimately it failed at the same point. If I turn machine back on and just try to run a spin cycle, the tub doesnt spin and I can hear the drain pump buzzing. If I empty the water our manually it will spin but if you run a full wash again it fails without emptying washer. Could this be a faulty drain pump?
Answer Hello Aaron, the code refers to a SudsDetect fault, meaning the control board has tried to run the drain pump and is still detecting a full tub of water which prevents spin cycle from occurring. You would need to check the tub to drain pump hose for any obstructions, also if it is clear it may be a drain pump problem. If you repost your question after doing that check with the model number we would be able to advise you with the drain pump part number. Read More... Answered by AppliancePartsPros.com | Monday, December 2, 2019