Customer Questions and Answers for Internal Unbalance Switch by Whirlpool

Hi Dan. There is a inertia unbalance switch part # WP22003302. It is mounted on the outer tub on the rt. side. By pass these 2- wires to momentarily see if this is the cause. Check the foot pads to see if they are still intact and gripping the floor OK. Is the shocks leaking ? This will permit the unbalance issue. Is the unit level front to back and side to side ? Are the leg lock nuts tight up against the base assy. while they are level ? You can use the tech sheet supplied w/ the unit folded in a packet and put the unit in a diagnostic mode to assist. Ohm out the motor windings. Check the tach. circuit for proper ohms and connections being tight. Are the motor and motor control board connections tight ? Thank You.