Dave for Model Number GEW9200LW1 My whirlpool duet dryer model GEW9200LW1 wasn`t heating, so I put it in diagnostic mode. All of the lights light up red, except for the completed cycle light was green unlike the rest. After few seconds, it showed error code E2 saying the thermistor was shorted. So i replaced my thermistor, The dryer still doesn`t heat, and the cycle complete light still lights up green in the diagnostic mode, but the error code no longer comes up. I had previously checked the heating coil and it reads 10 ohms and the thermal fuse had continuity and 0 ohms. Can you help? Thanks,,,Dave
Answer Hello Dave. Trace the voltage and see where your losing voltage at. It may be the main board or the motor not transferring power to the heater. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More... Answered by AppliancePartsPros.com | Thursday, June 4, 2015