Customer Questions and Answers for Door Trim Left (Wht) by Whirlpool

Dave, The APP parts diagram, is a pretty good facsimile,but here are the written instructions from the manual " 1. Turn off the electrical supply to the range. 2. Remove the oven door, and position it on a protected floor with the handle and outer door glass facing up. 3. Raise the top of the door and remove the two screws that secure the top of the door trim and the handle to the door liner, then remove the handle and top trim.4. Slide the outer door glass out of the bottom trim channel and install the new glass in its place. 5. Install the top trim and handle on the oven door and secure them in place with their two mounting screws. REASSEMBLY NOTE: The side trim on Whirlpool oven doors fits under the top edge of the outer door glass, and the side trim on Roper models fits over the top edge of the glass. Make sure that the trim is seated properly when you tighten the screws. 6. Reinstall the oven door on the range." Another note, if you purchased new side trim rails WP8523173 the screw holes in the new trim have been removed and replaced with "dowels" The dowels will be installed in the screw openings in the bottom trim rail WP8523178. Thanks and Good Luck