Jim for Model Number KUDS30IXSS6 I had water leaking from door corners, ordered a new door seal from you guys, still have leaks (not the door seal) during the wash cycle from below door and dripping from overflow. I have tracked the problem to a high water fill level. The overflow switch doing its job and I timed the fill cycle at 2 minutes and 25 seconds and that is correct, the overflow switch kicks in and shuts it off early. The water level is at least .5 inches over the heating element and the inlet valve does shut off tight. It seems that the fill rate is too high, I am on a well at 40-60 psi. Does the inlet fill valve have a flow control in it? Any help would be appreciated. Thanks for the fast service on the door seal.
Answer Hello Jim, This is normally caused by a water valve WPW10327249 that closes too slowly. This is either caused by low water pressure to the valve or a failing water inlet valve. If the water pressure at the valve is actually 40 to 60 PSI, the issue will be the water valve. Read More... Answered by AppliancePartsPros.com | Friday, October 18, 2019