Parts for Kenmore 346.2701080 (3462701080, 346 2701080): Attachment Parts

This part is a replacement hex bolt. This is a genuine OEM part made by MTD and has been sourced directly from the manufacturer. This part can be used to replace a broken, stripped, or lost hex bolt in a variety of outdoor power equipment models. Hex bolts are a standard piece of equipment hardware named for their hexagon-shaped head. They are critical for securing together different equipment components but can easily become corroded, stripped, lost, or otherwise ineffective, requiring replacement. When working on or near any mechanical equipment, it is important to verify that it is powered off and completely cooled down before starting any repairs. For more accurate information on how and where to install this hex bolt, the appropriate owner's manual and equipment diagrams should be referred to. As an authentic replacement part, this hex bolt is suitable for use on several different models of outdoor power equipment manufactured by MTD, Craftsman, and other brands. This is a genuine part made of high-quality, durable metal and is sold individually.

This wire retaining ring secures the door boot (bellow) to the front tub on front-load washers. It keeps the gasket seated to maintain a watertight seal, helping prevent leaks when the washer fills, agitates, and spins.

• Secures the door boot/gasket to the outer tub opening
• Maintains a watertight seal during wash and spin cycles
• Helps prevent the boot from slipping off the tub lip
• Common symptoms: water leaking at the front, a loose or detached boot, or a broken/missing ring

• Unplug the washer and shut off water; wear gloves and eye protection—the ring is under spring tension
• Release the outer boot clamp and fold the boot inward to access the inner ring
• Seat the boot evenly on the tub rim, then expand and fit the ring into its groove; verify it's fully seated all the way around
• Reassemble and run a quick test cycle to check for leaks

This electromechanical SPDT 24V relay switches a single circuit between two outputs to control motors, valves, or heaters. It provides the reliable on/off switching appliances need to run specific components when commanded. What it does:

• Energizes a 24V coil to open or close the common contact to the normally open or normally closed contact
• Controls motors, pumps, fans, or heating elements when the appliance control board sends a 24V signal
• Common replacement when an appliance component does not start or cycles incorrectly due to a failed relay
• Designed for panel or chassis mounting in appliance control systems

• Turn off and unplug the appliance before servicing to avoid shock or injury.
• Verify connector orientation and terminal fit; match wire positions exactly when replacing.
• If soldering or crimping, use appropriate tools and make secure connections to prevent intermittent faults.