Need Help?
Call
Fix a washer that stops mid-cycle or won't advance to drain and spin. This mechanical timer controls wash cycle sequencing. Moderate DIY repair.
The timer from APP was the same as the broken OEM part. Viewing a few youtube DIY videos made replacing the part easier than I thought. Read more
Fix a refrigerator with no lights, no cooling, or blank display. This power supply board converts AC to DC for electronic controls. DIY-friendly repair.
Measured power to power supply board (120V AC in, 12.5V and 26V DC out) 120V at input. 0V at output. Replaced power supply board. Refrigerator now works! Read more
Fix a blank or dim display on your oven with this electronic control board. Manages baking, broiling, and clock functions. DIY repair in 15-30 minutes.
This couldn't have been simpler! Removed the glass panel by taking out 4 screws on the bottom that were accessed by opening the oven door. Lifted up, then pulled the panel forward, released one electrical connection, and the panel was disconnected and could be laid on a flat surface. Unscrewed the four nut screws on the old control board with a socket set (you could use a small wrench, but it would be tedious), un-clipped the wide ribbon connection ( had to pry it off very gently to avoid... Read more
Fix F10 error codes, runaway oven temps, or ovens that won't heat with this range control board. Moderate DIY repair; disconnect power and remove back panel.
Looked it up on you tube found two possible problems, eliminated oven sensor, left only mother board, replaced, very simple procedure, all working well now. Read more
Refrigerator not cooling or running? This inverter control board supplies power to the compressor. Moderate DIY repair requiring basic electrical testing.
Compressor not running. Check power going to it and nothing. Tested ohms on the compressor. 8-10 ohms approx Lights and display all working normal so I assumed the main board was ok Replaced the inverter board. Confirmed there was 4-5bdc on the red and white trigger plug on the inverter. It’s a waveform that is there also but having voltage on the red and white wire of the inverter is a good sign the mother board is ok. I wanted to confirm the damper door was working properly. The damper is... Read more
Dishwasher won't start or buttons/lights don't respond? This electronic control board kit restores operation and cycle management. DIY-friendly repair.
Replaced control board with OEM part from ApplianceParts Pro - fit exactly and remedied the problems. Simple to replace - turn off power (circuit breaker), remove internal door panel, remove control board cover and unplug wires/LED leads (the LED lead connectors on the board have a square tension slip ring around them that hold the leads - just pull these up away from board and they will release the leads) and then remove the controller board housing. The controller board is held into the... Read more
Oven not heating properly or showing temperature errors? The relay control board sends signals to regulate heating elements. Moderate DIY repair.
Replaced both control and relay board with no success. Replaced heat sensor and that fixed it. Read more
Fix random beeping, locked controls, or self-cleaning errors. This control board governs display, timers, and temperature relays. Moderate difficulty.
I looked up the part numbers, ordered them from Appliance Parts Pro and they arrived the next day. Followed the video to replace the parts - it was super easy and now everything works great again! Saved lots of time and money. Read more
Fix a washer that won't advance through cycles or stops mid-cycle. This timer controls wash, rinse, and spin sequences. DIY repair in 15 minutes.
We had to order the entire timer assembly because the part taking the most abuse is plastic. Of course. Watched the video and easily did the repair. Thanks. Read more
Washer stops mid-cycle or won't advance through cycles? This timer controls cycle progression. Moderate DIY repair taking 15-30 minutes with basic tools.
With the help of the videos.... really made it easy and much better than the book----(which Shawn also got for me, and I can refer to if I cant access "Matt" on the video)....took all of 15 minutes once I had everything ready as the video said...and it worked just like he said Yea!!!! He made it so simple, my cat could've done it if she had hands... Read more
Fix F3E2 error codes, humming relays, or a dead oven with this range electronic control board. Restores cycle timing and reliable operation.
Repairs installed. Full test today. Install was easy. Read more
Fix dishwashers that won't start cycles, display error codes, or stop mid-cycle. This main control board manages all wash and drain functions.
My son-in-law checked it out, posing questions to an electrical support group, and determined I needed another control unit. NOTE: This had happened 3 years earlier, while the unit was still under warranty thankfully, but the certified repairman told me it would have cost me "out of pocket" over $400.00 to replace. My son-in-law ordered a replacement board, which arrived within 3 days. He then installed it and my machine now works like new! Read more
Fix a refrigerator that won't cool, has no display, or won't respond to settings. This control board restores function to your bottom-mount refrigerator.
Fix oven that won't heat to correct temperature or won't turn on. This control board regulates heating cycles. Moderate DIY install, 1-2 hours.
I put in a new oven control board. So instead of putting the temp knob 80 degrees higher than it should, I dont have to do that anymore. The best part is I get to make our gingerbread houses as gifts! Because of a great support staff that worked on sunday the two gals there know their stuff. Its nice to work with a nice and efficient co. Will be back when other stuff breaks down because when you fix one thing the other appliances get upset when they dont get any attention. Trust me this... Read more
Fix an oven that won't heat or display that's unresponsive with this range electronic control board. Restores temperature control and timer functions.
Took old board out and put in new board. When electricity was applied, it WORKED! I put silicone caulking in three cracks that water could get to the control board. Read more
Control board that mounts to the main control assembly. Replace when board is burned, damaged, or relays have failed to restore proper operation.
Replaced daughter board but problem persisted. Rather then buying a $260.00 control. I bought a new cooktop. I was afraid that also might not fix my problem. I was very much impressed with your tech. She done a good job trying to help me. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.