Control Board

Replaced daughter board but problem persisted. Rather then buying a $260.00 control. I bought a new cooktop. I was afraid that also might not fix my problem. I was very much impressed with your tech. She done a good job trying to help me. Read more

Ordered a new panel and replaced the old one Read more

The most challenging part of this was determining what the problem was. At first I thought the clutch (or related parts) had worn out, but by chance, I pulled on the timer knob, and the machine started spinning. When I let it go, it stopped. So clearly the spinning part worked. Then I watched a few videos about repairing a bad timer and determined that it was the likely culprit. I ordered the part. It was very simple to replace. And it worked perfectly. Saved me hundreds either in... Read more

I ordered the control board because the old one had many (about 30) opens on the back of the control board and the plastic cover for it was warped. Helpful notes; put front cover on before you connect the wiring. This will save you hours of being mad! All the plugins have different ends, you can't screw it up! Third note, those little plastic light transmitters can be put in wrong and it will not go together. Tabs go in! The one set by the start button can be put in backwards and looks correct.... Read more

Ordered new relay board and had it installed by a repair service tech. I had pulled a tendon in my right arm bicep and could not replace board myself. Read more

I replace the display. Read more

Replaced control Read more

It took about half-hour to change the control board. Read more

Measured power to power supply board (120V AC in, 12.5V and 26V DC out) 120V at input. 0V at output. Replaced power supply board. Refrigerator now works! Read more

It was a simple replacement. Read more

About a year ago, the washer was doing a similar thing, where it would shut off before the spin cycle started. The coin trap was completely clogged then, so I checked it first this time. It was clear, so I took the drain pump out and checked that as well. Nothing seemed to be physically wrong with the machine, so I put it in diagnostic mode, which gave me error code 43 when I tried the spin cycle. This one of the codes for a bad control board. Replacing the board only took about 15 minutes.... Read more

New circuit board. Read more

Googled my appliance model number for problem and indications were the control panel. I identified the part for model WDF510PAYBA. Ordered and Received part promptly and installed myself. Took some thought and effort but I am mechanical and it went in perfectly. Saved $100 by not calling a repair service out. Now all cycles and features are working again. Thanks for the quick service, the right part, and a return policy that made me comfortable if I messed up and ordered the wrong thing. Read more