Control Board

Fix an oven that won't heat or display that's unresponsive with this range electronic control board. Restores temperature control and timer functions.

This genuine replacement part is a user interface board for dryers. The user interface board is the circuit board that responds to the buttons located on the control panel allowing the user to adjust the dryer settings. If the dryer is no longer responding when buttons are being pressed then it might be time to replace the user interface board. Luckily this is a relatively easy repair.To replace the interface board begin by turning off the power to the dryer. Once the power has been shut off move the dryer away from the wall to gain access to the upper back panel. Remove the panel and locate the interface board. Snap it out of its brackets and remove the wire harness attached to the board. Reinsert the wire connector to the new interface and snap the new board assembly back to its original place.This OEM replacement part is sold individually and is compatible with General Electric, Hotpoint, and RCA brand Dryers.

Fix continuous beeping, blank display, or temperature control issues in your refrigerator. This control board restores normal operation. DIY repair.

This electronic main control board manages and distributes power to the appliance's key components. Replace a failed board to restore normal operation when the unit won't power up, won't start, or runs erratically.

• Regulates and routes incoming power to motors, fans, compressors, heaters, and valves based on signals from sensors and the user interface
• Coordinates cycle timing and system protections to help prevent component damage
• Logs or triggers fault indications when abnormal conditions are detected
• Common failure symptoms: no power, dead/unresponsive controls, intermittent shutdowns, or unpredictable operation

• Disconnect power at the breaker or unplug the appliance before servicing
• Handle the PCB by the edges and use ESD protection to avoid static damage
• Photograph wiring and move connectors one at a time to the new board
• Inspect connected loads (motors, heaters, compressor, valves) for shorts before restoring power

Fridge won't cool or displays blinking error codes? The main control board regulates temperature and defrost cycles. Moderately difficult repair.

This is an LED display module that mounts on the control panel of a range or oven. It shows temperature settings, cooking times, error codes, and other operational information. Replace this module if the display is blank, flickering, showing partial or garbled characters, or if segments of the readout are no longer illuminating.

Dishwasher won't start or LED lights not working? This electronic control board restores responsive controls and proper cycle execution. Moderate difficulty.

Fixes unresponsive touch controls and blank displays on your refrigerator. This interface board restores temperature settings and control panel functions.

If your oven won't heat or displays error codes, the relay board may have failed. This assembly routes power to burners and heating elements.

Control board that mounts to the main control assembly. Replace when board is burned, damaged, or relays have failed to restore proper operation.

Fix a dishwasher that won't cycle properly, hangs mid-wash, or resets to default settings. This electronic control board restores normal operation. DIY-friendly.

Fix a dishwasher that won't advance cycles or gets stuck in wash mode. This control timer restores proper cycle progression and timing functions.

Noise filter (line filter) that suppresses electrical interference on the washer power line. Protects electronic controls from power surges and reduces EMI. Replace if washer has intermittent operation or won't start.

Washer won't start or advance through cycles? This control board assembly restores cycle selection and timing. Moderate DIY repair for 4-cycle models.

Refrigerator not cooling or showing error codes? This main control board coordinates the compressor, fans, and defrost cycle. Moderate DIY difficulty.

This is a relay control board designed for dual oven configurations. It manages the electrical signals that switch heating elements and other oven components on and off during cooking cycles. Replace this board if one or both ovens fail to heat, heat intermittently, or if error codes related to relay failures appear on the control display.