Parts for Whirlpool WFG500M4HS0: Cooktop And Control Parts

This burner head is the replacement surface burner cap used on compatible gas ranges to distribute the flame under cookware for even heating. Restores proper flame pattern and efficient cooking when the original is damaged or worn. What it does:

• Directs and shapes the gas flame for consistent cooking performance
• Replaces cracked, warped, or corroded burner heads that cause uneven heating
• Helps correct ignition or flame-spread issues when the burner cap is compromised
• Fits the corresponding burner base to maintain safe, stable flames during use

• Turn off gas supply and power to the range before servicing
• Remove grates and old burner head; seat the new head firmly on the burner base
• Do not force or hammer parts; inspect burner base for debris or damage before installing

This burner head replaces a damaged or corroded surface burner to restore proper gas flow for stovetop cooking. It provides a stable base for the burner cap and helps re-establish consistent flame pattern and heat distribution. What it does:

• Directs gas to the burner ports, forming the flame for cooking
• Restores even flame pattern when original head is warped, clogged, or corroded
• Helps correct weak or uneven heating caused by a damaged burner face
• Can resolve ignition or lighting issues related to a cracked or clogged burner surface

• One replacement burner head

• Turn off the appliance and gas supply before servicing; disconnect power if applicable
• Remove burner cap and lift old burner head straight up; align new head and replace cap
• Hand-tighten and ensure proper seating—do not force or overtighten

This control knob replaces a worn or broken selector on your appliance, restoring a secure grip for turning settings and cycles. It provides a straightforward hardware repair to improve control and usability. What it does:

• Replaces a damaged or missing control knob so you can change settings easily
• Provides a secure push-on fit to stay in place during normal use
• Helps stop slipping or spinning on the control shaft caused by a stripped or cracked knob
• Works with the original control shaft and detents to restore tactile feedback

• One control knob

• Pull the old knob straight off the control shaft and push the replacement fully onto the shaft until it seats
• No special tools required for typical push-on knobs; use a flat tool only if the original is stuck
• Ensure the appliance is off and controls are cool before starting work
• If the new knob does not seat or align with detents, verify shaft type and orientation before forcing