Parts for Amana ASI2575GRB02: Dispenser Parts

This electronic control board replaces the appliance's main control module to restore proper cycle selection, timing, and console responsiveness. Use it when the original board is malfunctioning or causing intermittent control and cycle issues. What it does:

• Manages user console inputs and cycle commands across the appliance's control system.
• Sends signals to components like motors, valves, heaters, and displays to run selected cycles.
• Helps resolve symptoms such as unresponsive controls, error codes or flickering display, cycles that won't start, or unpredictable/intermittent operation.
• Interfaces with sensors and safety interlocks to coordinate normal cycle progression.

• Disconnect power (unplug or shut off breaker) before beginning any service.
• Handle the board carefully and avoid electrostatic discharge; use an anti-static wrist strap if available.
• Installation typically requires removing the console or control panel and disconnecting wiring harnesses—note connector locations before removal.

This genuine replacement fitting connects appliance water or fluid lines to internal plumbing, restoring a secure seal and proper flow. Use it to replace a worn or damaged connector and stop leaks or loose hose connections. What it does:

• Provides a sealed connection between a hose and the appliance plumbing
• Helps stop leaks from cracked, corroded, or loose fittings
• Restores reliable water or fluid flow through the supply line
• Fits where the original factory connector was used

• One replacement fitting as shown

• Turn off water and disconnect power to the appliance before starting
• Inspect and replace any worn O-rings or gaskets as needed
• Hand-start threads, then tighten to factory torque; avoid over-tightening

This replacement ice door is the inner dispenser door that covers the ice chute, helping keep ice contained and reducing warm air entry into the freezer. Fits models that use part W11678841. What it does:

• Covers the ice chute so crushed or cubed ice dispenses cleanly and stays inside the dispenser area
• Helps limit warm air and moisture from entering the freezer when the dispenser is not in use
• Prevents visible ice and debris from falling into the dispenser opening
• Resolves symptoms like a cracked or broken dispenser flap, ice falling out, or a door that won't close fully

• One ice door (inner dispenser door)

• Disconnect power to the appliance before beginning any repair
• Access typically requires removing the freezer door inner panel or dispenser bezel; keep screws and fasteners organized
• Handle plastic components carefully to avoid breaking tabs; test door movement before reassembling panels

This ice door is the interior flap that opens and closes the freezer dispenser chute to control ice release and help keep cold air inside. Replaces a cracked, warped or broken dispenser flap to restore normal ice dispensing and reduce drafts. What it does:

• Seals the ice chute when the dispenser is idle to help maintain freezer temperature
• Opens and closes with dispenser actuation to allow ice to pass through
• Prevents large debris from entering the ice chute and interfering with dispensing
• Commonly replaced when the door is cracked, stuck, or no longer sealing

• One ice door (single dispenser flap)

• Disconnect power to the appliance before attempting any service
• Remove the dispenser bezel or access panel per your model's service instructions to reach the flap
• Handle plastic parts gently to avoid cracking; verify proper orientation before reassembly

This retainer is a small mounting clip that secures an appliance component or assembly in place to prevent shifting and reduce noise or wear. It restores proper fit and alignment where a worn or broken clip allows movement. What it does:

• Holds panels, trim, or small assemblies securely to their mounting points
• Prevents rattling, shifting, or misalignment caused by a missing or damaged clip
• Helps maintain proper spacing so seals and connections stay aligned
• Works as a direct-fit replacement when the original retainer is broken or missing

• One retainer

• Disconnect power and, if applicable, water supply before starting any repair
• Remove surrounding fasteners or trim gently to access the clip; avoid forcing plastic tabs to prevent breakage
• Replace with the exact part number and ensure the component is seated fully before reassembling