Tim M Doylestown , PA March 11, 2016 Appliance: Frigidaire Washer GLTF2940FS1 Washing machine drum wouldn't agitate or spin Replaced the motor control board Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers, Socket Set
Emily W Merrick , NY April 30, 2015 Appliance: Frigidaire Washer LTF2940ES3 Wouldn't final spin Changed Door Latch Mechanism Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
James F Endicott , NY April 13, 2015 E56 high motor current Replace motor control board Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Tim P Warsaw , IN January 30, 2015 E56 Checked motor windings by checking resistance. Determined motor was good and replaced motor driver. Works fine. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers
Thomas H Morris Plains , NJ January 25, 2015 Appliance: Frigidaire Washer LTF2140FS0 The drain pump was not activated during final spin cycle Replacement of the control board corrected the problem Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Gennaro T Port Washington , NY November 09, 2014 Washer stopped spinning Replaced the motor control board. Appliance Part Pros is my go to resource I have repaired washer, dryer, cooktop Fridge. Saved hundreds in costly service calls and over priced repairs ! Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Denise S Chicago , IL August 16, 2014 Appliance: Frigidaire Washer LTF2140FS0 My washing machine water inlet valve had frozen water trapped in the rubber hoses this water would not flow through the valve when defrosted i had to replace the water inlet valve to release water The water ran on the motor control board shorting out the connection and I had to replace the board. Each connection was removed and the new board was replaced and connected by hearing a click to lock in the connectors. l secured the board to the floor of the washer by securing a screw. When the machine was turned on a buzzer sounded and the lady at the appliance pros told me that if I didn't secure the board to the floor it could shake during the spin cycle and the buzzer will sound. I had to remove the water hoses and go back to the board unscrew the screw and lock it in to the floor then the buzzer stopped going off and the machine completed the cycle. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Adjustable Wrench, Screwdrivers