How to Troubleshoot & Replace Frigidaire AP4358489 / 137006030 Control Board

Replace 

I watched your 10min youtube video on how to replace the electronic control board. The video was spot on. The washer is working perfect. FYI; replacing the board took 10min, but my washer and dryer are stackable and is in a small tight space, also the washer has a stacking kit (that supported the dryer on top of the washer) that kit was held down with double sided tape that prevent me from removing the top of the washer easily. 

Replaced the control board, following the appliance parts pros video. Saved $100 by doing it myself. 

The fix went great. Replacing the control board was super easy, it took about 15 minutes and once done the machine went right back to normal operation. 

Replaced the control board after checking error coads 

Replaced main control board 

Had code E43.. put in new Electronic Control Board ... Great Codes Gone.... Now I have code E59 ordered new part let's see if that works .. 

I replaced the control board. It fixed it. I was worried this wouldn't be the fix but it worked. 

Tested the door lock and it read 1600ohms, a little high. Close enough I though it was good but read someone else's post and they said to test the coil in the lock. It showed 1300ohms which his past said was bad so replaced the door lock and had the same problems. Ordered a control board and that fixed the problem. You could see a discoloration on the plastic where something had oozed out of the board similar to when a battery leaks. The only hard part is the wire ties clip into the board and are hard to her out. I broke one and replaced it with a conventional wire tie. 

Watched a video