Chris N Charlotte , NC April 20, 2014 Appliance: General Electric Electric Range JTP86BF3BB Burned out oven control I ordered in the part from you guys. Took 2 screws off the side of the display cover, pulled the front face off, removed the 4 screws holding the oven control on, unplugged the 2 bulkhead connectors inisde the oven, removed the old board, plugged in the new one, screwed down the new board, put the pannel back in place, installed the two side screws to hold the pannel in, turned the power on, tested the oven. Works perfect! Took me 10 minutes and 7 of that was trying to unplugg the old plugs from the bulkhead connector. Was a very easy project and saved me a ton of money using you guys. Note... The part appears more expensive than other sites, but if you read closely on the others, they dont come with the wiring harness. Yours did, and there was wire damage on the old unit, so a wire harness was a must have!! I would use you guys again in a second! Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
James P El Centro , CA October 26, 2019 Oven had code F0 bad oven control board Ordered a new oven control board and changed it. Oven works. Real easy to swap out Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Andrew M Windham , ME February 13, 2016 Appliance: Model KENMORE 911.47813201 The oven was not heating at all everything else worked fine i checked the control board and found a relay that had burned up I purchased the control board on a Sunday night and it arrived Tuesday with standard shipping. Replaced the board and it works great. It only took about 15 minutes to do and the hardest part was getting the old molex connectors disengaged to be able to plug in the new control board. I ended up taking the front trim off so I could get at the tabs on the connector from underneath. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Alika B Kahului , HI April 01, 2021 No bake or broil Replaced the oven control board. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Chris M Arvada , CO December 26, 2020 Appliance: Model JTP86B0F7BB Oven wouldn't shut off. Installed factory circuit board. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers, Socket Set
John G Sharps Chapel , TN October 28, 2016 Appliance: Model GE JTP86B0F5 30 INCH BUILT -IN OVEN WITH MICROWAVE Oven heaters would not turn on Replaced oven control board Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers, Socket Set