A little more challenging than initially anticipated due to difficulty un-installing old igniter. Tried to remove venturi burner assembly to facilitate disconnecting igniter outside oven but my venturi had a 2" wide L shaped bracket that came up from back of burner and over top of burner preventing burner from being lifted up and out. Watched every install and youtube video I could find and never found anything w this set-up. There seemed to be no way to remove burner without removing this bracket and there was no obvious way to disconnect bracket. The downward angle of the two igniter installation screws prevented using a nut driver or ratchet (no room). Fortunately the igniter screws were only hand tight and I was able to put a 1/4" socket on the nut heads (blindly) and unscrew the nuts w my fingers. Install of new a part was easy after that, though doing it while leaning into back of oven over open door takes a bit of flexibility and is a little tough on the back. All good now!