I replaced the compressor start relay by following the instructions on the video. It took me a while to clean out the area with a mini vacuum and wiping down the fan and other parts. The hardest thing for me was getting to the part. First prying the cover off of the old relay. And then getting the wires detached from the cover. My cover was a little different than the one on the video, it had a tab on top that I finally pried into an open position by wedging the screwdriver in. Then I could rock it off. Once it was released, the cables were still clipped onto the cover so I couldn't get the cover out of there. Figured out that the clip that was holding them slides out if you use a little flathead screwdriver to pry it out. Replacing the part was ridiculously easy after that. Success!