Nick H Springfield , MO June 15, 2015 Appliance: Maytag Top Loading Washer MAV5920EWW The washer would run for 15 seconds shut off and all the lights on the dial would blink I replaced the Washer Control Board in it. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Donald R Belleville , MI August 15, 2015 Power outage caused main failure 4 times After watching the maytag man fix it I could do it easily Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Jeannette M Southgate , KY March 04, 2017 Appliance: Maytag Top Loading Washer MAVT546EWW Power outage resulted in a fried control panel whirlpool washer Bought the control panel part suggested by these pros and it worked like a charm. Super easy to install; like clicking a part into a computer after removing 5 screws. The painful part was the cost, $165. Less than a new washer. Now I wonder if I should unplug the washer when not in use, or install a surge protector to prevent in the future. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Tom W Louisville , KY January 22, 2017 Appliance: Model AMANA Washer would not stay runnimg We had a service guy come and check out our non functioning washer. He wanted $440 to replace the washer control board and said it would be 10 days to 2 weeks to get the part. We said no thanks since we only paid $450 for the washer ten years ago. We planned on replacing the washer instead of repairing it. Then I found the part for $155, ordered it on Sunday and got it the following Wednesday. Took me 15 minutes to replace and the washer is working properly. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Ron L Bradley , IL June 05, 2015 Appliance: Model MAYTAG? After a mild storm start filling and stop after a few seconds or so lights flash a couple of times Bought a expensive printed circuit bd. and installed, just unplug several connetors and into new board, very easy. Will buy a surge protector now....do maintenance for a living, got the part in 2 days, I will use website again for sure. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Mary M Akron , OH January 24, 2015 Maytag clothes washer was stuck on first wash with all lights on the cycle status dial lit up From reading all I could, I guessed that the Washer Control Board was the problem and ordered it because I was told I could return it if it did not correct the problem. Received the Board two days later. Installed it without any instructions, making sure each plug I disconnected was correctly connected on the new Board. Reinstalled Board and washer works fine. Installation took 1.5 hours. Only problem was the fact that there were no instructions with the part or on line. With instruction I could have finished in one-half the time. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers
Nicolas M Indianapolis , IN January 17, 2015 Appliance: Maytag Top Loading Washer MAV5920EWW Wouldnt enter diagnostic mode Replaced 32 position rotary switch and circuit board. Parts arrived 3 days after order was placed which was great since local supplier said their order would take 7 to 10 days to arrive. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Richard B Canon City , CO June 12, 2014 Appliance: Maytag Top Loading Washer MAV5758EWW Maytag washer stopped working lots of dirty clothes LOND AGO I WORKED ON THESE THINGS IF I HAD TO------MOSTLY MECHANICAL PROBLEMS-----------------BUT NOW THE MECHANICAL PARTS ARE QUITE GOOD SO I DECIEDED TO ORDER THE CIRCUT BOARD THAT CONTROLED EVERYTHING-----------USING GOOGLE I FOUND SEVERAL PARTS HOUSES AND THE MORE I LOOKED THE CHEAPER I FOUND THE PART----------------APPLIANCE PARTS PROS WON AND THE PART CAME EVEN QUICKER THAN THEY STATED IT WOULD-----------I HAD IT INSTALLED AND THE WASHER WORKING VERY WELL IN LESS THAN 30 MINUTES-----------------I COULD NOT BE MORE PLEASED-----------RICHARD BARNES------COLORADO Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers