How to Troubleshoot & Replace Whirlpool AP6009736 / WP5701M796-60 Range Oven Control Board

The part arrived promptly. We unplugged the old one and plugged the new one in. We now have a clock and ovens again. I am grateful. 

Ordered and replaced the board including display face. Took an hour and all is well in the kitchen. 

After some research I was able to determine that the oven control board was the issue with my range. I ordered the part and received it within 24 hours after I ordered it, this was much faster than I expected since I did not pay for overnight shipping, I did pay for 2 day shipping and since it was shipped from the same coast (east coast) where I live it worked to my advantage. Installation was very easy, I started by turning off power to the range by unplugging it. I needed to remove the back cover panel with a screwdriver. Then another 4 screws held this part in place. I removed those and screwed the new board in. Then I transferred over the wire connector plugs from the old board to the new one, then plugged it back in to test. Everything worked perfectly so I unplugged it again and installed the back panels, plugged it in. The range has been working perfectly since I installed it. Thanks Appliance Parts Pros! 

Five easy steps: 1. Fry existing Oven Control Board while broiling steaks for Sunday dinner. 2. Order new Board on AppliancePartsPros.com Sunday evening. 3 Receive new Control Board Tuesday afternoon 4. 5 screws and 10 wire harnesses - unscrew, unplug, replace Board, replug harnesses, screws back... 5. Push stove back, flip on circuit breaker, finish broiling Sunday steaks. - BON APPETIT!... 

I checked on line to price the part through various sources and found that Appliance Parts Pros had the best price by far. I had ordered a part through them several years ago for a refrigeraor that I needed to repair, and they had the best price at that time. I ordered the part through Appliance Parts Pros and had the part within a couple of days. It took me about 45 minutes to make the repair and I once again have a fully functional stove. 

I went without a lower oven for six months because of the 400 dollar cost for a new board. Finally found replacement relay and was convinced that it was a simple job to replace the relay on the control board. A day of cussing later with a total absence of help from talented sons, I spent another day detailing the sick stove and assured myself it was indeed worth the 400. Another day and I had what looked like a reworked board. 30 minutes of fitting in the 4 sheet metal screws, then 2 minutes of hooking up the board and my double oven, dual fuel stove looks and works like new. 

Checked out problem, power source ok, determined the control was gone ... reported to have blown during last use, sparks etc, after oven use produced high volume of moisture in air duct ... board was dead. Ordered new control board on Thursday and received it on Friday (one day) put the board into Jenn-Air in about one hour ( getting to back of unit and then putting stove back in position) ... all is well in the kitchen. 

Ordered a new control board with touch screen. Rmoved old and installed new board and checked all connections. Powered up and it worked. 

Ordered a new control board and it was a very simple installation. I figure we saved at least $200 or more by doing it ourselves! 

Replaced the control board