Overall this was a pretty simple repair as it was just a part swap. The biggest challenge was de-icing the evaporator and it being a bit cramped working in the freezer. The job started with removing the door and the drawers. Then snap off the two plastic covers and take out the 4 screws the back panel. Disconnect the motor wiring harness gl; and remove the motor housing (2 screws). Remove the old motor from the housing (you can reuse the fan and the rubber gasket). Replace with the new motor and wiring harness. Then reassemble in reverse order; install the motor housing and reconnect the harness. Replace back panel and covers. Re-insert drawers and connect the door. All told took me about 45 mins to complete.