First checked to see if the lint trap for the drain pump was clogged, but there was very little lint in the trap. Ordered the "washer drain pump assembly" and followed the instructions that came with the new pump. I had also viewed 2 You Tube videos. After unplugging the power, removing the 3 screws on the lower front panel, disconnecting the power cord to the pump and removing the 1 screw to the pump assembly, I was able to pull the pump forward a bit so I could place some towels under the pump to catch water as it starts to come out when you SLOWLY unscrew the lint trap just enough to start a trickle of water. While the water was trickling out I used a shop vac to suck the water up while it was coming out. Used a "screw clamp" to reattach larger hose.