Do-It-Yourself Story

I replaced the membrane that I purchased at AppliancePartsPros. It was Easy Peasy! Seriously. Unplug the stove from the electrical outlet. Then I just had to unscrew about 20 screws to release the membrane from the panel and the controller board. Then I the new membrane in and screwed it back in along with the controller board. Last step was to attach the two ribbon cables. I used to work with electronics, so I remembered that I had to open the clips on the connectors to slide the ribbon cable in and then snap the clips back. Once I did this I put the back plate on and plugged the stove back in. I heard a beep, reset the clock and tested the over and voila it worked perfect. Doing this installation myself saved me a LOT of money too ! Very happy with the results. This all took me about 30 minutes.