Followed the repair video which was well made and did not have any problems repairing the drum seal. Also replaced the drum drive belt since the dryer was 9 years old. I did use a couple of books to place under the front of the drum after removing the bulk head to keep the drum level. This made it much easier to remove and replace the belt on the idle pulley and the motor pulley. When putting on the new drum seal the last 8-10 inches was tight and when trying to pull the seal in place it would slip off the drum. After several tries I took and placed the new seal until the last 8-10 inches and then applied two 12 inch quick grips with rubber tips to each side of the seal that was placed on the drum and then I could pull the last tight part of the seal and place on the drum easily.