Jay S Hammond , IN February 07, 2017 Appliance: Model 11029828801 My kenmore washer model 11029828801 was agitating during the fill cycle and the tub would only partially fill also at the end of the spin cycle rinse water was spraying in resoaking the clothes I read the FAQ section of Appliance Pros parts web site. I found out I needed to replace the temperature control switch, WPW10248240, to correct my problem. This switch also controls the tub filling water level based on air pressure via the attached vinyl tubing. I ordered the switch and the tubing, WP353255, in case mine was no longer any good, and I also ordered the retaining clips for the control cabinet, (2) of WP8312709, because they can be damaged when accessing the controls. My new parts arrived quickly and I installed the new switch the same day I received it along with the retaining clips. My tubing was still good so I did not install it since I would have to remove the entire cabinet to replace it. My washer is now operating like new and I am very happy with Appliance Parts Pros. They are a class act web site and the FAQ section of the site is extremely valuable for helping troubleshoot any appliance. My repair took less than 15 minutes to complete. 55 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes