Do-It-Yourself Story

Replaced 3-sided gasket on washer & bottom gasket on door. 2.5 hours to do the former job. Most of this time spent cleaning old rubber & RTV glue out of groove. Followed instructions that came with new gasket. Wrapped edge of putty knife with 2 layers of electrical tape to avoid damaging gasket while pushing outside edge of gasket into groove. Latter job only took about 10 minutes. No glue involved. Had to spread groove ends a bit with screwdriver so that I could get the leading edge of the gasket started. Tapped groove ends with a hammer when I was done.