I turn off breaker to shutoff electricity. I took out the 2 screws that was holding the washer under the counter to pull out the washer. Pull out far enough to get to the left side of washer (as you are looking at the front). Unscrew the 2 screws holding the medal plate protecting the Assy-Case part. You will need a pylier to squeeze the hose clamps to remove 4 hoses. disconnect the 2 connectors to the 2 sensors cable. Make sure you reach in side the washer and turn the cap 1/4 turn that is against the left inside wall. This is what is holding the part against the wall (save the rubber washer on the outside to put on your new part. Connect all the hoses to new part and connect the 2 sensor cables to washer. Attach the part with rubber washer you save to the wall and reach inside washer to put that cap back on with 1/4 turn. start a load and check for leak by the 4 hoses. I wipe with dry towel and then start a load. Once it is running let it finish and check for leaks. put metal plate back on to protect the new part and slide washer back into the space under counter and screw the 2 screws under the cabint to keep it in place