So I ordered the part over-nighted as our house really needs a washer. There were no instructions in the package like the video said there would be, though I am not really sure they would be needed. The pump arrived and a flange that holds a mounting bushing was broken in the package. Superglue and epoxy repaired this as there was no time to get a new pump. Old pump came out ok except the hose clamps were positioned where it was hard to get a plier on them. There was about 8-12 oz of water that came out. My pump is the alternate mounting as discussed in the online video but that was no problem. All the parts fit well and the pump slid into the mounting holes just fine. I changed the orientation of the clamps to one where I could get the pliers on easily. One trick I did was moving the clamps back far enough to get hose fully engaged before moving the clamps into position. Tested the clamp tightness on a rinse and drain cycle and closed it all up. Overall took about 30 minutes not counting the part repair time. Would have been less if the hose clamps weren't positioned facing down.
Add a flashlight to your tool list.