Parts for Frigidaire FES353CCWG: 05 - Door Parts

Length: Approx. 82 1/2"

This refrigerator/freezer door gasket creates an airtight seal around the door to help maintain proper temperature and reduce energy use. It replaces a worn or damaged seal to improve cooling and reduce frost buildup. What it does:

• Seals the cabinet to keep cold air in and warm air out
• Helps prevent excess frost and moisture inside the compartment
• Reduces compressor run-time caused by air leaks
• Restores proper door alignment and consistent cooling

• Disconnect power and remove food from affected compartment before starting
• Remove the old gasket and thoroughly clean and dry the gasket channel before installing
• Press the new gasket into the channel evenly, starting at a corner and working around the door
• Check the seal by closing the door; adjust or reseat as needed for a uniform contact

This white handle trim restores the finished look and grip area on compatible appliance doors. It replaces a cracked, faded, or missing trim piece to improve appearance and create a clean edge around the handle area. What it does

• Covers and protects the handle mounting area while providing a smooth, finished appearance
• Replaces trim that is cracked, warped, discolored, or otherwise damaged
• Helps prevent sharp edges and improves the grip area for normal door use
• Matches factory styling so the door looks original and uniform

• One white handle trim piece as shown

• Basic removal of the old trim and reattachment of the new trim; fasteners and clips are present before installation
• Use proper tools to avoid scratching surrounding surfaces; support the door or panel if needed
• Disconnect power or follow appliance-specific safety steps when working near electrical components
• If fasteners or clips are missing or damaged, replace them before completing installation

Hex washer head ,10-32 x 0.375. Ground

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts